I am using BQ76952 on a custom board with SPI and 3.3V LDO enabled by default. I have used an MCU (3.3V powered by external source) to configure the registers in RAM. I have never programed the OTP ...

I have come across SBL boot in MCU+SDK that it has a secure boot support. My question is in an AM62X platform for a fully secured device (HS-SE), if it is possible to use the M4F core with full ...

Q2. Do I need a pull-up for 1G? (Datasheet say" Typically connected to VDD with external pullup resistor", but just to confirm.) Q1: You should pull up your SDA and SCK lines to VCC. The figure ...

We are doing the EMI/EMC analysis of our BMS in the Ansys AEDT. For the same we need the unencrypted PSpice or IBIS model of BQ76952PFBR IC so that we can use it in Ansys .So can you provide the ...

This utility has selected a 560/2xx-class product. This utility will load the program 'bh560v2u.out'. E_RPCENV_IO_ERROR(-6) No connection: emulator was not found ...

I am using MSP part for as a master for IC communication. I came across a form "Application to Use Texas Instruments Incorporated UNIVERSAL SERIAL BUS VENDOR ID". When we need to get this one - if we ...

AM243x can support etherCAT thanks to the PRU-iCSSG. PRU-ICSSG can output the SYNC0 signal for synchronization with the EtherCAT master. Which pin of the Sitara can be used to output the SYNC0 signal, ...

I have a customer using TPS546D24S, this chip does not have FB pin, can only be adjusted by IIC? He wants to output 0.88V voltage, can it be achieved? This device uses the VOSNS and GOSNS pins to ...

I have designed my own board based on AM2634 MCU and try to connect and load the program via XDS110. I get the following error: "ASSERT: 0.1s: soc/am263x/soc_rcm.c ...

about 5pcs IC I2C can not ACK from BQ27426,It get ACK OK after I2C add 1M pull down resistor,we test I2C sequency and it is OK. For normal operation, it is necessary to use the recommend 10k-Ω pull up ...

There is no functional difference between the two. The difference is the available carrier package quantity, as shown at the bottom of the datasheet in the "Packaging Information" section, or you can ...