I am using BQ76952 on a custom board with SPI and 3.3V LDO enabled by default. I have used an MCU (3.3V powered by external source) to configure the registers in RAM. I have never programed the OTP ...

I have come across SBL boot in MCU+SDK that it has a secure boot support. My question is in an AM62X platform for a fully secured device (HS-SE), if it is possible to use the M4F core with full ...

we would like to convert one of the outputs from the LMK to differential LVDS using a balun. Is it necessary to ac couple the buffer output like in the schematic below? Any other ...

Hi, I'm looking for any information you can provide on voltage and current noise parameters for the LM6172QML across temperature. I'm particularly interested in the upper extreme, e.g. 125C. I ...

I am using MSP part for as a master for IC communication. I came across a form "Application to Use Texas Instruments Incorporated UNIVERSAL SERIAL BUS VENDOR ID". When we need to get this one - if we ...

I have a customer using TPS546D24S, this chip does not have FB pin, can only be adjusted by IIC? He wants to output 0.88V voltage, can it be achieved? This device uses the VOSNS and GOSNS pins to ...

I have designed my own board based on AM2634 MCU and try to connect and load the program via XDS110. I get the following error: "ASSERT: 0.1s: soc/am263x/soc_rcm.c ...

about 5pcs IC I2C can not ACK from BQ27426,It get ACK OK after I2C add 1M pull down resistor,we test I2C sequency and it is OK. For normal operation, it is necessary to use the recommend 10k-Ω pull up ...

There is no functional difference between the two. The difference is the available carrier package quantity, as shown at the bottom of the datasheet in the "Packaging Information" section, or you can ...

I use the gstreamer api to test plugin v4l2h264enc performance. The pipeline like: gst-launch videotestsrc ! video/x-raw,width=1920,height=1080,format=NV12,framerate=30/1 ! v4l2h264enc ! avimux !