One of the biggest downfalls to affordable 3D printers is the cost cutting of crucial parts, like the z-Axis. Almost all consumer 3D printers use standard threaded rod for the z-axis, which should ...

Part of the fun of 3D printing is that it can be used for a wide array of projects—organizing your desk or your kitchen, ...

Check out this 3D printer ... The Z axis uses two motors mounted along the bottom of the cube. These raise and lower the bead, instead of moving the extruder itself. All-in the printer should ...

then you get to run the Z axis tilt adjustment to make sure the printer is level, then you get to do the automatic bed mesh, and then you get to do the calibration prints to line up X and Y ...

However, if you are new to 3D printing, having an extra set of hands for the initial assembly can be helpful. Once constructed and powered on, the printer handles calibration, and once done ...

But there is a z-axis change so we can build up one layer at a time.” One of the most common types of 3D printing is fused deposition modeling, or FDM. “It’s the cleanest with regards to ...

Stability is critical for 3D printing, and the QIDI Plus4 addresses this with an independent dual Z-axis motor drive. Both the screw and optical axis have been upgraded from 8mm to 10mm ...